Automatic Programming Of Parameter "C" (Pulses Of The Speed Sensor) - Redexim SPEEDSEED 1100 Manual Del Usuario

with "Un" = 1
UC 300
+ -
mph
Prog.
Select R eset
8.3 Automatic programming of parameter "C" (pulses of the
speed sensor)
It is possible to program parameter C automatically: after entering the programming
phase as instructed above, and with "C" shown on the display followed by the value
currently programmed, press both the "+" and "-" buttons at the same time and the
following appears on the display
At this point, travel 100 metres (or 330 feet) in the machine and the number will
increase automatically on the display. After covering this distance, press the "Prog"
button to confirm the data. It is advisable to repeat this operation at least twice.
If you try to acquire a value of less than 20 pulses, "Err" appears on the display and
the UC 300 retains the last valid value to have been saved.
12
Name of parameter:
Description:
Programmable range:
Default value:
-
Select
UC 300
+ -
-
Prog.
Reset
UNIVERSAL COUNTER UC 300
C
Pulses of the speed sensor
after every 330 feet covered
by the machine
20 to 999
Steps of 1 pulse
200