Adjustable Comfort Features; Setup; Operation Checklist - Titan LazyLiner Pro Instrucciones De Uso

Ocultar thumbs Ver también para LazyLiner Pro:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 26

Adjustable comfort features

Adjustable Seat
The seat on your LazyLiner unit can be adjusted or fitted and
positioned to provide you with a better comfort level for your daily
operation if needed. Figure 7 shows the seat in a right side offset
position.
1. For changing the left/right position of the seat, remove the
nuts below the seat tracks, and align the seat tracks with a
different set of holes (Fig. 7, item 1) in the seat frame. The seat
can be positioned right or left side offset, or in the middle of
the seat frame.
2. The seat can be adjusted back-to-front with the hand lever (2)
underneath the left side of the seat. Pull the lever and adjust
the seat backwards or forwards to desired position.
1
Adjustable Pedals
The pedals on the LazyLiner can be adjusted to multiple angles as
well as adjusted to an upper or lower position. Using these features
can help reduce foot and ankle fatigue, or provide a little more
legroom or height to help reach the pedals better.
The LazyLiner is shipped with the pedals in the DOWN position.
Follow these steps to adjust the position of the pedals.
1. Locate the two set screws underneath the pedal that attach
the pedal to the shaft. Loosen these set screws using a hex
wrench.
i
If you plan to change the height of the pedals,
completely remove the set screws. If you are
just adjusting the angle of the pedal but not the
height, the set screws do not need to be completely
removed, just loosened.
LazyLiner Pro • Elite
GB
2. While set screws are loosened/removed, reposition the pedal
to desired height and angle. To put the pedal in the UP
position, run the pedal shaft through the bottom hole in the
pedal.
3. Replace and/or tighten the set screws to secure the pedal.
i

Setup

Install the battery (Elite only)
2
The LazyLiner Elite does not include a battery. One must be
purchased separately prior to use in order for the electric start to
work.
1. Refer to the Subaru engine manual included with the
LazyLiner for the appropriate battery specifications.
2. In the compartment under the adjustable seat, loosen the bolt
that secures the battery bracket to the frame.
3. Install the battery and hook the battery cables to the
appropriate terminals: red to positive (+) terminal; black to
negative (-) terminal.
4. Secure the battery bracket to the side of the battery to hold it
in place. Tighten the bracket bolt to secure.
Install the trailer hitch
1. Install the trailer hitch to the back of your line striping
equipment. Follow the separate instructions included with
the LazyLiner.
2. Lift the locking lever on the coupler bracket on the LazyLiner
and place it over the trailer hitch. Hang the LazyLiner on the
striping equipment and make sure that the hitch engages.
Secure the hitch with bolt and split.

Operation Checklist

R eview the pre-operation check as follows:
1. Recheck that all components are correctly installed to insure
safe operation
2. Check engine oil.
3. Check transmission oil.
4. Fill fuel with non-leaded gas in tank.
5. Check tire pressure.
7
If the set screws are not sufficiently tightened, the
pedals will not engage the pedal shaft, and the
throttle will not operate correctly.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Lazyliner elite02900400290041

Tabla de contenido