Baxtran SCU Manual De Instrucciones página 37

SPEED 1
•Use the key
to exit from the configuration and go back to the menu LF4)
LF 4
BLINF
LF 5
DISPLAY
ZP 0 OFF
LF 5
ZP 1 One division will not show being at zero
ZP 2 Two division will not show being at zero
ZP 3 Three divisions will not show being at zero
ZP 4 Four divisions will not show being at zero
ZP 5 Five divisions will not show being at zero
*This function is going to be blocked when UF-5 is in mode HOLD 1
*The value of factory is ZP 0
DISPLAY
LF 5
• Press the key
automatically.
ZP 0
• Use the key
ESC to exit from the configuration and go back to the menu LF4)
LF 5
EQUIPMENT LOCK
DISPLAY
nonE
LF 6
DON'T MODIFY, IN NO WAY, THIS PARAMETER. IT MUST ALWAYS BE CONFIGURED AT
nonE.
!
The change of this parameter implies the blocking of some functionalities.
and then the key
DESCRIPTION AND SEQUENCE OF USE
DESCRIPTION AND SEQUENCE OF USE
to start or the key
and the key
LF 6
DESCRIPTION AND SEQUENCE OF USE
to select the speed of the AD converter ( press the key
to exit from the menu and the scale will start again
to select how many divisions will show when in zero ( press
USER'S MANUAL SCU EN
37