Mettler Toledo IND780 Guia De Instalacion página 37

2.9.1.2. Harsh Enclosure
The harsh enclosure is made of stainless steel and designed to rest on a flat surface such as a
table or desk top, or to be mounted to a vertical surface with optional mounting brackets. In desktop
configuration, the front panel angle is approximately 70 degrees from vertical. In wall mount
configuration, the front panel is approximately 40 degrees from vertical, and reversible (angled up
or down).
2.9.1.2.1. Desktop Mounting
If the IND780 terminal is to be placed on a flat surface, the four rubber feet included with the
terminal should be adhered to the bottom of the enclosure to prevent sliding. Peel each foot from
the protective paper and press it onto one corner of the bottom of the enclosure, as shown in Figure
2-7.
2.9.1.2.2. Preparation for Wall Mounting
An optional wall bracket kit is available for wall mounting the IND780 harsh enclosure to a vertical
surface. To prepare the enclosure for wall mounting, follow these steps:
1. Establish orientation of enclosure (above or below eye level)
2. Install enclosure on brackets
3. Mark attachment points
4. Install mounting hardware
5. Mount terminal hardware
2.9.1.2.3. Setting Front Panel Orientation
Establish whether the terminal will be mounted above or below eye level. If it will be mounted at or
below eye level, the orientation of the front panel must be reversed. Follow these steps:
1. Open the enclosure.
2. Loosen and remove the two nuts securing the two metal cables that hinge the front cover to the
64063214 | 07 | 02/2018
Figure 2-7: Rubber Feet for Desktop Mounting
rear housing.
METTLER TOLEDO IND780 Division 2 and Zone 2/22 Installation Guide 2-17