Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5 - INSTALLATION
5.2 - THERMOSTAT INSTALLATION
•Disconnect the power supply from the device
•Fasten the base of the thermostat to the recessed box
(or to the wall) via the paired holes (fig. 5):
A-A
for a round box (60 mm diameter) with clips
EN
B-B
for a round or square box with screws
C-C
for a rectangular box (3 places) with screws
N.B.
: fig.5, " " = removable areas for wires to be inserted (only flexible ones)
D
•Implement the electrical connections as shown in the relative paragraph,
whilst paying particular attention when mounting on a wall without a
recessed box as the wiring must be placed properly for it to not interfere
when the body is closed.
•Apply the thermostat body to the base as shown in fig. 6.
•Press slightly until you hear the fastening teeth click into place.
•To remove the thermostat from the base, use a small screwdriver
to lever the fastening teeth (fig. 7).
30
Fig. 5
B
D
D
D
A
A B
B
D
B
120
18
Fastening teeth
Fig. 6
C
Fig. 7
Publicidad
Capítulos
Tabla de contenido
