System Software Information; Possible Problems And Solutions - Perry 1TPTE011B Manual Del Usuario

11 - CONFIGURATION MENU (installer)

11.10 - SYSTEM SOFTWARE INFORMATION

From normal thermostat operation, pressing for
conf rm with i OK the item Set PROG
information about the installed firmware.
Press the Mode key to return to the previous menu or press
This information is useful in the event of request for technical support.

12 - POSSIBLE PROBLEMS AND SOLUTIONS

PROBLEM
The thermostat display is OFF
The display flashes the symbol
The display shows a steady symbol
The thermostat works but the system does not start
The temperature fluctuates too much between hot and cold
In OFF operation (Winter ), the Set antifreeze
temperature is not displayed
5 secs. the Mode key
->, using keys select item
OK to exit the menu.
CAUSE
Batteries not installed
Wrong battery polarity
Dead batteries
The batteries are running low
The batteries are dead
No power to the system
The thermostat is not connected properly
The thermostat is not set correctly for the
type of system
The antifreeze temperature has been excluded
Example:
, select and
INFO to obtain
Firmware version
Set the antifreeze temperature by following
the instructions in paragraph 10.1
Firmware revision
SOLUTION
Check that the batteries are installed
Check polarity of batteries
Replace the batteries
Replace the batteries within 15 days
Replace the batteries
Make sure the switch or differential
protection device is not set to OFF
Contact the installer
Contact the installer
EN
47