Correction Of Room Temperature Reading - Perry 1TPTE011B Manual Del Usuario

11 - CONFIGURATION MENU (installer)

11. - CORRECTION OF ROOM TEMPERATURE READING

4
If for any reason the thermostat must be installed in a position where the measured
room temperature might be affected (e.g. perimeter wall which is on average colder in
winter and warmer in summer than the rest of the dwelling) the device has 2 separate
parameters to adjust the room temperature measured in the
modes.
From normal thermostat operation, access the menus by pressing and holding the «
• Through the path -> Set PROG ->, select item
Press OK to confirm.
OFFSET for winter mode ( )
The display alternates the empty fields to be inserted (
temperature value.
•Use the key to enter positive values, the
Possible correction -3.0 °C (-5.4 °F)
- - - -
default 0.0 °C/°F =
At each selection the display will show the new correction value (e.g.: 0.6°C) alternated
to the detected temperature value (e.g.: 21.2°C).
•After performing the correction press «OK».
The display shows the OFFSET for the Summer mode
as per the above procedure or press the
to cancel any previously set temperature corrections take OFFSET
back to .
Winter and
Set COrr.
- - - -
) with the current
key to enter negative values (sign «-»).
÷ 3.0 °C (5.4 °F)
( ); proceed with the correction
Mode key twice to exit.
Summer
Mode » key.
OK
/OK
EN
or
OK
or
41