Operating Your Whirlpool - Kohler K-1338 Manual De Instrucciones

Operating Your Whirlpool

- Turn the jet trim fully counterclockwise. Position the jet nozzles so they face down toward the basin.
NOTE: The water temperature in the whirlpool should never exceed 104_F (40_C). A built-in heater automatically
maintains the water temperature when the whirlpool is running, as long as the water temperature does not
exceed 104_F (40_C). The heater will disengage at higher temperatures.
- Close the drain, and fill the whirlpool to a level at least 2" (5cm) above the top of the highest jet. Use your hand to
test the water temperature for comfort and safety, then carefully enter the bath.
- Press Power to turn on the whirlpool. The heater will also turn on and the whirlpool will start at medium volume.
- Increase or decrease the water flow by pressing the up or down arrows on the keypad. An indicator bar in the
center of the keypad shows the water flow volume.
- Adjust the jets for optimum air/water mixture. Turn the jet trim clockwise to reduce the flow, and
counterclockwise to increase the flow. Position the jet nozzles to direct the water flow as desired to maximize your
hydro-massage experience.
- The heater automatically engages when the whirlpool is turned on. To turn the heater off, rotate the outer ring
until the heater mode is flashing and press "OK". Press "OK" again to turn the heater back on.
- Press Power a second time to turn off the whirlpool.
NOTE: Your whirlpool will automatically stop after approximately 20 minutes of continuous operation. You can
restart the whirlpool, if you desire, by pressing Power.
B
1022414-5-
Fill with water 2" (5cm)
above the highest jet
Turn the jet trim
clockwise to
decrease the flow
Position the jet
nozzles to direct
the water flow as
desired
Turn the jet trim
counterclockwise to
increase the flow
6
Kohler Co.