Remote Control; Fcc Compliance - Kohler K-1338 Manual De Instrucciones

Remote Control

The remote control places the whirlpool functions at your fingertips to further enhance your bathing experience.
The functions of the remote are identical to the user keypad. You may turn the whirlpool on and off, turn the
heater on and off, increase or decrease the water flow, turn the neckjets and backjets on and off, and adjust the
neckjet/backjet pulse speed by the press of a keypad.
The mode selector button functions in the same way as the outer ring. When "M" is pressed, one of the modes
will flash on the user keypad. If "M" is pressed again, the next mode in clockwise order will flash. When the
desired mode is flashing, press "OK" to activate it. The active mode will illuminate.
When the Flexjet mode is active, the arrows will increase or decrease the water flow volume. When the neckjet or
backjet mode is active, the arrows will increase or decrease the neckjet or backjet pulse speed.
The waterproof remote control is designed to be used in the bath and will float in the water.
Two AAA batteries are used in the remote control. To replace, simply unscrew the end cap and insert the batteries,
as shown above. Tighten the end cap securely, making sure the end cap makes contact with the seal.

FCC Compliance

FCC ID : N82-KOHLER001
Canada ID : 4554A-KOHLER001
Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to
the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by the party responsible for compliance could void the users
authority to operate the equipment.
B
1022414-5-
Power
Activates
Mode Selected
Mode
Selector
Increases
Flow or
Pulse
Decreases
Flow or
Pulse
8
Kohler Co.