Preparing For Use; Flushing The System - brondell CORAL UC300 El Manual Del Propietario

PREPARING FOR USE

TURN ON WATER & CHECK FOR LEAKS
Before turning the cold water valve back on, review the installation instructions to
ensure that the T-Valve and water hoses are connected correctly and securely.
1. Turn on water supply
a. Open the T-Valve by turning the valve arm 90° as shown.
b. Turn the cold water supply valve at the wall counter-
clockwise to turn on. The cold water supply will then
begin to supply water to the Coral UC300 or UC100.
2. Checking for leaks
a. Once the water supply has been turned on, check for any
signs of leaking throughout the system.
b. If no leaks are found, wait 5 minutes and check one more
time. If still no leaking, then continue to next step to flush
the system.
Failure to properly install this product or to properly check for leaks may cause damage
to the property. In these instances, Brondell, Inc. will not be held responsible for any
damages.

FLUSHING THE SYSTEM

1. Turn the Indicator Faucet on and let the water flow from the faucet for 5 minutes continuously to
flush the system and activate the filter(s).
2. Check one last time for any leaks during this process.
3. Your Coral system is now ready to use!
15