Troubleshooting - brondell CORAL UC300 El Manual Del Propietario

TROUBLESHOOTING

Problem
Incoming cold water supply valve is
There is no water flow.
turned off.
The tubing is bent or twisted.
The water supply valve is not turned on
all the way.
There is not enough
water flow.
The temperature of the tap water
decreased sharply.
The life of one or more of the filters has
run out.
The water tastes or
The life of the filters has expired.
smells bad.
The tubing is not inserted into the quick
connector completely.
There is a leak
surrounding one of
the hose connections.
The end of the tube is damaged.
Water is leaking from
An O-ring on one of the filters is
the head Connection
damaged.
Assembly.
Possible Cause Solution
Turn on incoming cold water supply valve.
Straighten out the hose. If water flow is still
impacted, replace the hose.
Ensure the water supply valve is open
completely.
If the water temperature decreses due to
inclement weather, water will flow more
slowly through the system than normal.
Replace the filters, per the instructions on
Page 17.
Replace the filters, per the instructions on
Page 17.
Ensure the hose is inserted completely.
Cut the tubing off at the damaged area and
connect the tube again, or replace the tubing
entirely.
Determine which filter or filters are affected
and contact the Brondell service center.
19