Replacing The Filters - brondell CORAL UC300 El Manual Del Propietario

MAINTENANCE

REPLACING THE FILTERS

1. Close the T-Valve under the sink to shut off the flow of water
to the Coral.
2. Once the T-valve is shut off, turn the Indicator Faucet on all
the way and keep it on until all the residual water in the
tubes has been expelled.
3. Turn the filter(s) to be replaced 90° to the left, until the filter
comes out of the Filter Head Connection Assembly.
For the Coral UC300, remove the remaining two filters.
For the Coral UC100, the process is complete.
4. Install the new filter(s). Review the procedure outlined on Page 13.
5. Open the T-Valve to restore the flow of water and turn the Indicator Faucet on for 5 minutes
continuously to flush and activate the new filter(s).
Be sure to reset the Indicator Faucet by following the next steps.
17