Sirona DAC PROFESSIONAL Instrucciones De Uso página 80

Chapter 4 – Sterilizing
During the drying phase the drying time that has elapsed is shown on the display. This alternates with the
message:
To terminate a program, proceed as follows:
Press the (S) key.
1.
Then acknowledge the subsequent confirmation prompt Immediate removal "Stop" by
2.
pressing the
(S) key.
The terminated program is confirmed on the display with "Drying interrupted."
NOTE!
The confirmation prompt remains on the display for about 5 seconds. If the (S) key is not pressed
again, the program continues with the normal sequence.
After ventilating the chamber, the display shows the message Universal Program successfully
ended alternating with the message:
If a log printer or another output medium is connected to the autoclave and the immediate output is set to
Yes, a note with "Drying interrupted" is recorded in the log.
Manual termination before starting the drying phase
If you terminate a program before the drying has started, the load is still non-sterile. The program is
considered not to have run successfully.
To terminate a program, proceed as follows:
Press the (S) key.
1.
Acknowledge the subsequent confirmation prompt "Terminate program?" by pressing the (S) key
2.
again.
NOTE!
The confirmation prompt remains on the display for about 5 seconds. If the (S) key is not pressed
again, the program continues with the normal sequence.
Depending on when the program was interrupted, the pressure in the autoclave is released or the the unit
is ventilated. The appropriate message is shown on the display.
After the pressure is released or the autoclave is ventilated, the user is requested to confirm the
termination of the program.
On the display the message Termination end alternates with Acknowledge with "-" key.
Press the (-) key.
3.
The display shows the message Unlock door with "+" key alternating with the display of the
previously selected program.
After pressing the (+) key, you can open the door.
4.
The log includes the note "Program interrupted / Load not sterile!".
22
Immediate removal
press "Stop"
Last batch no. 46
Acknowledge with "+"
Programm Start-Stop
Start-Stop
Programm