Displaying The Log Memory - Sirona DAC PROFESSIONAL Instrucciones De Uso

Chapter 5 – Logging
Output all saved logs
To output all saved logs at a later time, proceed as follows:
Select the "Function" set-up menu by pressing the (+) and (-) keys at the same time.
1.
The display shows the message Function: Last batch no.
Navigate using the (+) or (-) keys until the message: Function: Log output is displayed and
2.
press the (P) key.
Navigate using the (+) or (-) keys to the message: Output saved cycles.
3.
Press the (P) key to start the output of the selected program. Once the output is complete the
4.
display shows the message:
If you would like to leave the submenu without outputting the log, press the (S) key.
NOTE!
Interrupting the log printer during the log output is only possible by switching the device off at the
power switch or by interrupting the power supply to the printer.
To leave the menu, press the (S) key. The display shows the message of the set-up menu
5.
Function: Log output.
By pressing the (S) key again, you leave the menu completely and return to the initial operating state of
the display.

Displaying the log memory

If the printer or another output medium is connected and initialized, you can check how many logs have
already been saved in the log memory of the autoclave.
Proceed as follows:
Select the Function set-up menu by pressing the (+) or (-) keys at the same time.
1.
The display shows the message Function: Last batch no.
Navigate using the (+) or (-) keys until the message: Function: Log output is displayed and
2.
press the (P) key.
Navigate using the (+) or (-) keys to the message for the assignment of memory.
3.
To leave the menu again, press the (S) key 2×.
28
Output saved cycles
In use: 26
Free: 14
Start-Stop
Programm
Start-Stop
Programm