Maverick STRADA MSC-30BR-WP Manual De Instrucciones página 10

Caution This is an extremely powerful brushless motor system. We strongly recommend removing
your tyres for your own safety and the safety of those around you before performing
calibration and programming functions with this system. Please keep your hands, hair, and
loose clothing clear from the gear train and wheels of an armed high performance system.
Rubber tyres will "expand" to extreme size on a high speed vehicle. DO NOT hold the vehicle in the air and run
it up to full throttle. Tyre failures at that speed can cause serious injury! Make sure your tires are securely glued
to the rims and check them often! Always disconnect the battery from the ESC when you are fi nished using your
vehicle.
The switch on the ESC controls the power that is delivered to the receiver and servos. The controller will always
draw current when it is connected to the battery and will completely discharge batteries if they are connected or
long durations. This may cause failure of your batteries.
ESC Setup
Important !
Hold down the setup
button while turning on
the ESC.
Leave the trigger in the
neutral position.
Press the setup button.
Green LED
LED LED
fl ashes and a
Beep sound
comes from the
motor.
If the LED on the speed control does not work as described below, the speed control may not be setup correctly. Repeat the
above process.
THE LED STATUS IN NORMAL RUNNING:
a) In normal use, if the throttle stick is in the neutral range,neither the red nor green LED will light.
b) The red LED lights when the car is run forward or backwards and will fl ash quickly when the car is braking.
c) The green LED lights when the throttle stick is moved to the top point of the forward zone (full throttle).
You must set up the ESC before running the fi rst time. Initial setup, it is not required
before every run.
Move the trigger to full
throttle.
Press the setup button.
Green LED
LED LED
fl ashes twice.
Beeps twice from
the motor.
LED LED
Move the trigger to full
brake.
Press the setup button.
Green LED
LED LED LED
fl ashes three
times. Beeps
three times from
the motor.
10
Release the setup button
once the Red LED starts to
fl ash
When the process has
fi nished, motor control will be
activated in 3 seconds
No LED Lighting
LED