Electronic Speed Control Setup - Maverick STRADA MSC-30BR-WP Manual De Instrucciones

Electronic Speed Control Setup

MSC-30BR-WP Features:
Model
FWD Continuous / Burst
Current
REV Continuous / Burst
Current
Resistance
Application
Motor Limit 2S LiPo /
6 cell NiMh
3S LiPo /
9 cell NiMh
Battery
Built-in BEC
PWM Frequency
Dimension
Weight
Caution Failure to follow these instructions can cause injury to yourself or others. You might also
cause property damage or damage your kit.
Always disconnect the battery from the speed controller after driving.
Never connect the speed controller incorrectly or with reversed polarity.
Wrong connection or reversed polarity will damage the speed controller.
Please use an optional capacitor with the motor for good frequency reception.
Do not use a motor under 12T when using 2S Lipo or 6 sells NiMH (Example: 11T,10T, 9T and lower turn motors),
Using a lower turn motor may damage the speed controller. (Although your motor may be in the safe range,
your ESC may go into overheat protection mode due to your choice of gearing or track conditions (off-road, high
traction, etc.))
Do not use a motor under 18T when using 3S Lipo or 9 sells NiMH (Example: 17T,16T, 15T and lower turn
motors), Using a lower turn motor may damage the speed controller. (Although your motor may be in the safe
range, your ESC may go into overheat protection mode due to your choice of gearing or track conditions (off-road,
high traction, etc.))
After running in water, dry off any excess water from ESC and connectors.
During and after running, your speed controller will become hot. Do not touch the heatsink your with bare hands
otherwise, they will get burned.
The speed control has 2 types of battery modes to choose from depending on which type of battery you use
(NiMH and LiPo). Setup for the proper battery is needed. If you do not setup your speed control correctly, your
battery may explode, swell, smoke, or become useless.
MSC-30BR-WP
40A / 180A
20A / 90A
FWD: 0.002 Ohm; REV: 0.004 Ohm;
1/10 scale On-Road and Off-Road
540 or 550 size motor ≥ 12T
RPM < 30000 @7.2V
540 or 550 size motor ≥ 18T
RPM < 20000 @7.2V
5-9 cells NiMh or 2-3S LiPo
6V/2A
1KHz
46.5x34x28.5mm
65g
7