Items Required For Operation; Charging The Battery Pack; Installing The Transmitter Batteries; Installing The Battery Pack - Maverick STRADA MSC-30BR-WP Manual De Instrucciones

Items required for operation

4 * AA Batteries for the
Transmitter

Charging the battery pack

Always use the included charger for the included battery pack. Charging time for an empty battery pack is about 6
hours. Do not charge the battery pack longer than 6 hours to avoid overheating and battery damage.
Cautions
• This charger can be used only for the battery pack included in this kit.
• Do not charge the battery pack for longer than 6 hours. Overcharging generates excessive heat and will damage
the battery pack.
• Use the charger with adult supervision. Do not use the charger near water or when wet.
• Do not use the charger if the wire is frayed or worn. If the wire is frayed or worn a short circuit can cause a fi re or
burns.
• If you are not sure about the level of the battery pack before charging use it in the vehicle until the vehicle slows,
leave to cool and then recharge.
1. Select your regions electrical mains plug and attach it to the charger. Always use the correct mains plug version for
your country.
2. Connect the charging socket to the supplied battery packs power plug. The connectors are sided and have a clip to
secure it in place. Do not force together and always check you have the connection the right way round.
3. The charger will automatically start to charge your battery pack. Do not leave connected for more than 6 hours on
a fl at battery pack and always observe the cautions above.

Installing the Transmitter Batteries

Installing the battery pack

Open the battery holding
tray to expose the empty
battery slots.
Insert 4 AA batteries
into the marked spaces.
Please note the correct
direction of the batteries
You need to insert the
battery pack in the open
section for the battery.
Use the chassis cut-out
for corner wiring if
needed. Use the straps
provided to secure the
battery in place.
1
4
Incorrect battery insertion
could damage the transmitter
2.4Ghz technology has done
away with the need for long
extendable aerials. The Aerial
on your transmitter is located
internally
Once fastened and secured
please connect the battery
plug into the speed controller
plug noting correct polarity.
Red to red, black to black.