Installation Clearances; Venting Requirements - ELICA EPR628SS Guía De Instrucciones Para Instalación

Installation Clearances

A. 12" (30.5 cm) min. upper
cabinet height
B. 30" (76.2 cm)
cabinet opening width*
C. 24" (61 cm) min. 36" (91.4 cm)
suggested max. bottom of
cabinet to cooking surface
For gas range installation: Mount this hood so that the bottom
edge is at minimum 27"(68,5 cm) above the cooking surface.
For electric range installation: mount this hood so that the bottom
is not less than 24"(61 cm).
*NOTE: This range hood is set to 30" (76.2 cm) cabinet width x
12" (30.5 cm) deep cabinets.
D. 12" (30.48 cm) cabinet
opening depth*
E. 15" (38.1 cm) min. clearance
upper cabinet to countertop
F. 36" (91.4 cm) base cabinet
height

VENTING REQUIREMENTS

■ Vent system must terminate to the outdoors, except for no
vented (recirculating) installations.
■ Do not terminate the vent system in an attic or other enclosed
area.
■ Do not use a 4" (10.2 cm) laundry-type wall cap.
■ Use metal vent only. A rigid metal vent is recommended.
Plastic or metal foil vent is not recommended.
■ The length of the vent system and number of elbows should
be kept to a minimum to provide efficient performance.
For the most efficient and quiet operation:
■ Use no more than three 90° elbows.
■ Make sure there is a minimum of 24" (61.0 cm) of straight
vent between the elbows if more than 1 elbow is used.
■ Do not install 2 elbows together.
■ The vent system must have a damper.
■ Use clamps to seal all joints in the vent system.
■ Use caulking to seal exterior wall or roof opening around the
cap.
■ The size of the vent should be uniform.
Cold weather installations
An additional back draft damper should be installed to minimize
backward cold air flow and a thermal break should be installed to
minimize conduction of outside temperatures as part of the vent
system. The damper should be on the cold air side of the thermal
break.
The break should be as close as possible to where the vent
system enters the heated portion of the house.
Makeup air
Local building codes may require the use of makeup air systems
when using ventilation systems with greater than specified CFM
of air movement. The specified CFM varies from locale to locale.
Consult your HVAC professional for specific requirements in your
area.
5