Fault / Malfunction Codes; Display Of Operating Data And Counters - Sime Brava Slim HE 25/55 ErP Manual De Instalación Y Mantenimiento

3.5

Fault / malfunction codes

Type No. Description
ALL 02 Low water pressure in system
ALL 03 High water pressure in system
ALL 04 Domestic hot water sensor fault
ALL 05 Delivery sensor fault
ALL 06 No flame detection
ALL 07 Safety thermostat intervention
ALL 08 Fault in the flame detection circuit
ALL 09 No water circulating in the system
ALL 10 Auxiliary sensor fault
ALL 11 Gas valve modulator disconnected
ALL 12 Incorrect configuration of the open /sealed chamber
ALL 13 Smoke probe intervention
ALL 14 Smoke probe fault
ALL 15 Fan check cable disconnected
ALL 18 Condensate level fault
ALL 28 Maximum number of consecutive releases
ALL 30 Return sensor (SR) fault
ALL 37 Fault due to low network voltage
ALL 40 Incorrect network frequency detected
ALL 41 Flame loss more than 6 consecutive times
ALL 42 Button fault
ALL 43 Open Therm communication fault
ALL 44 No flame valve opening time sum anomaly
ALL 62 Self-calibrating procedure is required
ALL 72 Incorrect positioning of the delivery sensor
ALL 77 EV2 SGV current max/min absolute limits error
ALL 78 EV2 SGV current upper limit error
ALL 79 EV2 SGV current lower limit error
Fault on the valve control logic line/valve cable
ALL 80
damaged
ALL 81 Block due combustion during start-up
ALL 82 Block due to numerous combustion control failures
ALL 83 Irregular combustion (temporary error)
Flow rate reduced for (presumed) low pressure on
ALL 84
mains gas
ALL 88 Internal error (board component protection)
ALL 89 Unstable combustion feedback signal error
ALL 90 Combustion set cannot be reached error
System has reached maximum air correction error
ALL 92
(at the minimum flow rate)
ALL 93 Combustion set cannot be reached error
ALL 95 Flame signal micro interruptions error
ALL 96 Block due to clogging in smoke outlet
ALL 98 SW error, board start-up
ALL 99 General board error
90
3.6

Display of operating data and counters

Once the boiler is operating a qualified technician can view the
operating data and the counters as follows:
– from the operating screen in the mode enabled at that
moment (WINTER n or SUMMER
– go into "DISPLAY" by pressing the buttons
for more than 3 seconds until the following screen
same time
appears
From this point, the technician has 2 options:
– scroll through the list of "information (PAR)" and "counters
by pressing the button
(PARc)"
– display the "activated alarms" (no more than 10) by pressing
the button r
– Once in this section, proceed with button
When all the values have been displayed, exit the menu by
pressing and holding down the button
seconds until the initial screen is displayed.
EN
l )
r and <
at the
t . Scrolling will be in sequence
t or r .
y for approximately 5