Resetting The System Setup Menu To Factory Default - YSI PRO20 Manual De Usuario

RESETTING THE SYSTEM SETUP MENU TO FACTORY DEFAULT

To reset the Pro20 settings to factory default, press the down arrow key until the
Reset - box is highlighted, then press enter. The instrument will ask you to
confirm the reset. Highlight Yes and press enter to continue with the reset or
highlight No and press enter to cancel the reset. A Factory Reset will not affect
data saved in the unit's memory.
The following will be set in the Pro20 after performing a factory reset:
Parameter
Temperature Units
Dissolved Oxygen Units
Pressure Units
Dissolved Oxygen Sensor Type
Membrane Type
Salinity Compensation Value
DO Local%
One Touch Cal
Display Contrast
Auto Shutoff
Auto Stable
LDS (Last Digit Suppression)
Audio
Language
Dissolved Oxygen Calibration
Barometer Calibration
*It is recommended to perform a barometer and dissolved oxygen calibration
after performing a reset.
Reset Defaults
o
C
mg/L and %
mmHg
Last Setting Confirmed
Last Setting Confirmed
0.0 ppt
Off
On
Set to mid range
30 minutes
Off (0.0 % Change and 10 secs)
Off
On
English
Reset to factory default, 100% for
enabled membrane and sensor*
Reset to factory default*
16