Publicidad
Idiomas disponibles
Idiomas disponibles
12. Using two 1/2" or adjustable wrenches, remove the transport
wheels from their current location and install them onto
the brackets you just installed. Leave the old transport
wheel brackets in place, as that is where a footstrap can be
attached. See Figure G.
NOTE: It is critical that the washers and wheel get installed in the
same order and orientation as they were on the original brackets.
Do one wheel at a time and if the wheel does not spin freely after
you are done, double check against the other wheel to make sure
everything is in the right order.
Figure G
13. Re-install the head end rail cover plates on the same side you
removed them from.
NOTE: If you will be installing a Tower System next, leave the
head end rail cover plates off.
14. Your legs are installed and you may now carefully lift and turn
your Allegro Reformer back over onto the legs. Re-install your
shoulder rests, risers, and ropes.
Do not forget this
washer between the
wheel and bracket.
Leave this
bracket here.
15
Publicidad
