Digital Instrument Board; Important - Malaguti XTM 2007 Manuel Du Propriétaire

DIGITAL INSTRUMENT BOARD

This new digital instrument board offers several additional func-
tions - compared to traditional ones - through which driver may
optimally manage his/her vehicle. The panel is equipped with a
warning light signalling shortage of coolant or improper connec-
tion with the radiator's thermostat. This light comes on automati-
cally. To select the functions shown on the display, press the MODE
button located at the front of the left hand control (see page 17).
Available functions are:
0-40 (acceleration from 0 to 40 km/h),
TIME (clock),
LAP (chronometer),
AVE (average speed),
TD (partial distance),
TOD (total distance),
BAR GRAPH with three functions: battery charge level, coolant tem-
perature, number of motor revolutions.
In the England version, the display will use miles not
kilometers. The digital instrument board only works if
the battery is connected. If the battery is flat, replace it
immediately. When the battery is replaced or the fuse is
removed, power is disconnected; any memorised set-
tings will be reset, except the total distance driven.
Replace the flat battery with a new one; if the problem remains,
call an Authorised MALAGUTI
Do not use your vehicle when no function appears on
the display or when functions appear partially, since the
instrument board is not in the condition to provide suffi-
cient information about your vehicle.
Service Centre.
ENGLISH
INSTRUMENT AND CONTROL FUNCTION
Setting
Power up the instrument board by connecting the battery to the
vehicle's cables. Put the key in the ignition switch and turn it to
The names of stored vehicles appear successively on the display:
before selecting your type of vehicle, check the information given
on the anti-tampering label under the seat (see page 58). When
the code of your model appears on the display, press the MODE
button, to make your selection. If you choose the wrong model, you
will be shown improper information (speed, km, etc.). If you choose
the wrong model, turn the panel off, wait for about two minutes and
repeat the above operations in the correct manner.
These operations must be repeated every time the bat-
tery is disconnected.
Mile or kilometre selection
If you are driving in countries with different measurement systems,
you can change the unit of measurement of speed (instant and
average) and distance from kilometres to miles and vice versa. To
make your selection, first of all the vehicle must be stationary. Now
hold the MODE button down for 5" after selecting the TOD function.
When „Mph" and „Km/h" appear, give the MODE button short
presses until the unit of measurement starts flashing. Hold the
MODE button down to save your selection. The instrument board
will return to its normal display mode. Any stored information (with
the exception of TOD) will be reset
IMPORTANT: using a unit of measurement that differs
from the one used in the country where you are driving
may lead to improper calculations, especially concerning
the vehicle's speed. Consequences include exposure of
the driver and others to dangers, as well as fines.
.
3
13