Positioning The Joint-Stick - Inmes IM-4P Manual De Intrucciones

7.5 - Positioning the joint-stick

Fig. 29
INMES INDUSTRIAL LTDA - GRAMPEADORA IM-4P – UNDERPINNER IM-4P
ENSAMBLADORA IM-4P
Fig. 27
To perform the joining process follows here under
procedure:
Place one of the moulding legs in position against
the fence 04 figures 29 and 32 and loosen the
stops 02 and 07 Fig. 29. Now position the joystick
01 Fig. 29 about 5mm from the rabbet to insert the
first nail and slide the stop 07 Fig. 29 against the
joystick and tighten the stop and this become the
rear stop. Now slide the joystick toward the front
to locate the second nail about 5mm from the
frame corner and tighten the stop 2 Fig. 29 and
this will become the front stop.
Fig. 30
Fig. 28
Fig. 31
42