How To Remove The Nailing Head And Clean It - Inmes IM-4P Manual De Intrucciones

! Screw the lubricator glass back on making sure the O-ring is sitting correctly
in the housing.

8.5 - How to remove the nailing head and clean it

For operator safety always disconnect the air source before cleaning, lubricating
or performing any maintenance.
a) Using the 5mm Allen key loosen the locking screws 01 and 02 Fig. 41 of the
nailing head. Then loosen the locking screws 03 and 04 of the magazine Fig. 42;
b) Then use your hands pull back the magazine a little bit Fig. 43. Now you are
able to remove the nailing head and accomplish your regular maintenance;
INMES INDUSTRIAL LTDA - GRAMPEADORA IM-4P – UNDERPINNER IM-4P
ENSAMBLADORA IM-4P
Fig. 39
Fig. 41
Fig. 40
Fig. 42
46