Every 8 Working Hours; Every Week; Air Filter Lubricator And Oil Lubricator (See Item 6.4); Air Filter Lubricator - Inmes IM-4P Manual De Intrucciones

If glue accumulates on the nailing head, wipe if off before it dries, otherwise it
will have to be scraped off or removed with the solvent recommended by the glue
manufacturer. Be sure glue does not dry on the upper clamp pads because it will damage
the top of a frame.

8.1 - Every 8 working hours

a) Check compressed air condensation in the filter glass;
b) Check the nailing block and make sure it is clean. If not clean it up as per
instructions listed on item 8.5.

8.2 - Every week

a) Check the oil level inside the filter lubricator;
b) In case oil is needed add for pneumatic circuits low density and follow the
instructions recommended on item 6.4.

8.3 - Air filter lubricator and oil lubricator (See item 6.4)

For operator safety always disconnect the air source before cleaning
lubricating or performing any maintenance.

8.4 - Air filter lubricator

When compressed air leaves the air source it comes with water, impurity and dust,
so the functions of the filter lubricator is to filter the compressed air eliminating water
and collecting dust and other impurities inside the filter glass. Every source of
compressed air differs from one another, so consecutively, quantity of water and
impurities are collected. That's why we strongly recommend that the customer verify
daily the oil level and water inside the air filter lubricator. When it is necessary to
empty the water inside the filter glass, (it is not necessary to shut air supply) just
loosen the drain located under the bottom of the filter 02 Fig. 39. However, we do
recommend cleaning the filter lubricator located inside the filter glass at least once a
week. In order to clean it up, proceed as follow:
! Shut air supply;
! Unscrew the filter glass by turning clockwise direction;
! Unscrew the filter (white piece) by turning clockwise direction and use
compressed air to clean it up Fig. 40;
! Once these procedures are done the screw filter back to its original position;
INMES INDUSTRIAL LTDA - GRAMPEADORA IM-4P – UNDERPINNER IM-4P
ENSAMBLADORA IM-4P
45