Adjusting The Feet; Air Evacuation - grandimpianti GD6 Instrucciones De Funcionamento

Installation
5. Fit the plastic cups so that the "tags" marked
with arrows are against the front edge or side
edge of the cover and press them firmly onto
the cover. Then break off the remaining tags.
6. Push out the knock-out hole on the back of the
dryer (you must not remove it, just open it)
using a hammer and screwdriver.
7. Push the tumble dryer in under the metal
brackets. At the same time keep the front edge
raised by 10mm to 20mm.
8. Lower the tumble dryer's front feet into the
plastic cups and adjust the dryer to ensure that
it is balanced.

Adjusting the feet

Screw the feet in or out so that the tumble dryer
is steady and balanced on the floor or on the
washing machine. Then tighten the lock nuts.
Locking nut

Air evacuation

Waste air from the tumble dryer must be taken to
an evacuation duct or to an outlet in the wall using
the vent hose supplied.
Connection to the tumble dryer
The tumble dryer has three options for venting
air: at the back, on the right side and on the left
side. One hole is open when the tumble dryer is
supplied. The other two have covers. The tumble
dryer comes with a connector (1), a plastic band
(2) and a vent hose (3).
1
2
3
Fit the air evacuation system as follows:
1. Slip the vent hose onto the connector and
secure it using the plastic band.
2. Remove the plastic cover if you want to fit the
vent hose to one of the holes other than the
one already open.
3. Insert the connector with the vent hose into the
opening.
4. Place the cover over the open hole.
19