Tabla de contenido
Publicidad
Stationary Regeneration System Functioning Instructions
Step
Park the vehicle at a safe place and far from flammable materials.
1
Do not operate the power take-off or any equipment installed on vehicle during the regeneration. The engine speed could
increase unexpectedly.
Before commencing the stationary regeneration (by pressing the optional button STATIONARY REGENERATION), the
2
four conditions below should be verified:
2A
Park Brake Actuated
Note: If any one of the above conditions is changed during the stationary regeneration process, the regeneration will be interrupted
and shall be restarted. Other conditions that inhibit stationary regeneration are certain engine diagnostic trouble codes (DTC)
and other problems on vehicle's eletcric system. The MIL lamp and other lamps are indication of problems that can inhibit
the stationary regeneration. Eliminate all failure and diagnostic trouble codes before performing a stationary regeneration.
64
2B
Transmission at Neutral
Procedure
2C
Not Stepping on Pedals.
If the pedal is pressed
during the regeneration,
the process will be
interrupted
2D
Coolant Temperature
above 170°F or 77°C
932H00604106
Publicidad
Tabla de contenido
