Trace Measurement - Auto - Promax PROLITE-50 Manual De Instrucciones

5.2.2 Trace Measurement - Auto

Auto measurement can be applied in case that the length of optic fiber is
unidentifiable. Prolite-50/51/52 auto select adequate range for measurement.
Steps for Auto measurement:
•
Parameter configuration: for detailed operations, please refer to 3.4.3.2,
Parameter Configuration on Prolite-50 Menu Bar. Set range to"AUTO".
•
Measure: press [
figure 37 and 38.
Page 38
Qui ck r ef er ence
1. Connect t he f i ber and pal m OTDR .
2. Pr ess or t o sel ect i con , Pr ess
¡ ® Ent er ¡ ¯ t o act i vat e f unct i on .
3. Sel ect t o set par am et er s : I O R,
Scat . Coef . , pul sewi dt h , di st ance ,
avg . Ti m e , Ref l . Thr e . , NonRef l . Thr e
and End Thr e et c .
4. Pr ess ¡ ®
Run/Stop
5. Pr ess t o vi ew m easur e r esul t s .
( Pa g e Up Pa g e Do wn
Figure 35.- Help.
Qui ck r ef er ence
6. Pr ess or t o m ove act i ve m ar ker
7. Sel ect or
hor i zont al l y , and sel ect
t o zoom t r ace ver t i cal l y .
8. Sel ect t o swi t ch m ar ker s .
A
B
9. Sel ect or t o br owse event .
10. Sel ect t o save f i l es .
11. Sel ect t o open saved f i l es .
W ar ni ng : Al ways Avoi d Naked Eyes
Exposed t o Laser !
( Pa g e Up Pa g e Do wn
Figure 36.- Help.
] to start measurement, and the interface is as shown in
USER'S MANUAL. PROLITE-50/51/52
¡ ¯ t o st ar t . . .
Qu i t
t o zoom t r ace
or
Qu i t
)
)
11-2015