Program The Collar Receiver For Up To Four-Dog Operation (Modes 1 & 8) - SportDOG Trainer SDT30-11226 Manual De Funcionamiento

1. Program the Remote Transmitter to modes 2-7
(see page 10).
2. Flip the toggle switch to the left position to
program the fi rst Collar Receiver.
A. Turn the Collar Receiver off.
B. Press and hold the On/Off Button. The Receiver
Indicator Light will come on, then turn off in 4-5
seconds. If the On/Off Button is released too early,
the Receiver Indicator Light will begin its normal
fl ashing. If this occurs, start over and repeat from A.
C. After the Receiver Indicator Light has turned
off, release the On/Off Button.
D. Press and hold the Upper Button on the
Remote Transmitter until the Receiver Indicator
Light fl ashes 5 times. You may need to hold both
units 60-90 cm from each other. If the Receiver
Indicator Light does not fl ash 5 times, start over
and repeat from A.
3. Program the second Collar Receiver the same way using A. through D. above, but
with the toggle switch set to the right position.
___________________________________________________________
Program the Collar Receiver for Up to
Step
8
Four-Dog Operation (Modes 1 & 8)
SportDOG
(See page 16, for the SportDOG Add-A-Dog
Grip Trainer
1. Program the Remote Transmitter to Mode 1 or 8 (see page 10).
2. Flip the toggle switch to the left position.
3. Program the fi rst Collar Receiver:
A. Turn the Collar Receiver off.
B. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then
turn off in 4-5 seconds. If the On/Off Button is released too early, the Receiver Indicator
Light will begin its normal fl ashing. If this occurs, start over and repeat from A.
C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Receiver
Indicator Light fl ashes 5 times. You may need to hold both units 60-90 cm from each
other. If the Receiver Indicator Light does not fl ash 5 times, start over and repeat from
A.
4. Program the second Collar Receiver using A. through D. above, but using the Lower
Button in place of the Upper Button.
5. Flip to the toggle switch to the right position.
6. Program the third and fourth Collar Receivers using A. through D. above, for both the
Upper (Dog 3) and Lower (Dog 4) buttons.
12
® ®
Add-A-Dog Receivers must be purchased to train additional dogs.
™ )
www.sportdog.com/international
Set toggle left for Dog 1
and right for Dog 2
®
receiver that will work with the Pistol