Prepare The Collar Receiver - SportDOG Trainer SDT30-11226 Manual De Funcionamiento

Step

Prepare the Collar Receiver

2
Charge the Collar Receiver
1. Lift the rubber cover protecting
the Collar Receiver Charging Jack.
2. Connect the charger connector to
the Collar Receiver Charging Jack.
3. Plug the charger into a standard
household receptacle using the
adaptor plug, if necessary.
4. Charge the Collar Receiver for
24 hours for the fi rst charge.
Recharges take only 12 hours.
Note: The Receiver Indicator Light
will fl ash after 12 hours of charging.
For the fi rst charge, continue to
charge the Collar Receiver for an
additional 12 hours.
5. When charging is completed,
replace the rubber cover.
If the Collar Receiver is used in or around salt water, the Collar Receiver should be
rinsed with fresh water following each use. Prior to rinsing, the power cover should be
removed from the power plug socket and left out until the Collar Receiver has air dried.
To Turn the Collar Receiver On:
1. Press and hold the On/Off Button until the
Receiver Indicator Light comes on
and the Collar Receiver beeps 5 times.
2. Release the On/Off Button.
The Receiver Indicator Light will fl ash until the
Collar Receiver is turned off. The fl ashing light
indicates the Collar Receiver is ready to receive a
radio signal from the Remote Transmitter.
To Turn the Collar Receiver Off:
1. Press and hold the On/Off Button until the Receiver Indicator Light comes on and
the Collar Receiver beeps 2 times.
2. Release the On/Off Button.
To extend the life between charging cycles, turn the Collar Receiver off when it is
not in use. Approximate battery life between charges is 40 to 80 hours, depending on
frequency of use.
6 www.sportdog.com/international
Charger connector placed
in Collar Receiver Charging Jack
On/Off Button