Machine Introduction; Important Safety Information - edenox DPC-28 Instrucciones De Instalación, Uso Y Mantenimiento

1. MACHINE INTRODUCTION

1.1 Introduction to machine and models:
Plate dispensers are used to store, transport, distribute and heat plates. There are two versions depending on
the diameter of plates: versions without a heating system (180-280mm) DPN-28 and (240-340mm) DPN-34;
versions with a heating system (180-280mm) DPC-28 and (240-340mm) DPC-34.
A 480W heater is provided in the chamber of the dispenser, located centrally on the axis of the device. The
dispenser is thermally insulated to prevent it from fast cooling. Plates are stored on a moving platform mounted
on guides and suspended on springs matching the load.
The basket dispenser is used to store, transport, and distribute the baskets of industrial dishwashers. As in the
plate dispenser, baskets are located on a platform suspended on a spring system and positioned on guides.The
dispenser are designed to be enclosed underneath a worktop.

1.2 Important safety information:

The plate heating dispenser is powered by electricity. Only personnel trained in the use
of professional gastronomic equipment correctly and safely may operate the plate
dispenser and the basket distributor.
Only personnel skilled in servicing of professional gastronomic equipment may maintain
the dispensers.
While using the basket/plate dispenser, strictly adhere to the safety instructions below:

Be careful while near the chamber of the heating plate dispenser; its maximum operating
temperature can reach 90°C.

Make sure that no liquids are spilled over the heating elements of the plate dispenser.

Before any cleaning procedure, make sure the dispenser has reached the ambient temperature, the
thermostat control is set to zero, and the device is disconnected from the power supply.

In case of a fault, disconnect the device form power supply and contact service personnel

The device may be connected to power supply only after the fault is removed.
The following is strictly forbidden:

Cleaning and repairing when the dispenser is connected to the power supply and switched on.

Leaving the device unsupervised when it is operating.

Keeping up the maximum power and temperature of the device when it is empty.

Using the device when it is not earthed;

Operating without protective clothing;

Carrying or transporting the device without a pallet or a suitable platform.
The manufacturer shall not be held liable for any damage attributable to the failure to follow the
instructions contained in this manual, hence it is recommended that you carefully read all information
herein.
Keep the manual for later use.
WARNING:
Do not use the device if it is faulty.
1
ENGLISH