Description Of The Control Panel; General Safety Rules; Machine Cleaning And Maintenance Routine - edenox DPC-28 Instrucciones De Instalación, Uso Y Mantenimiento

3.2 Description of the control panel:

At the bottom of the device a control panel is located, forming part of the power cable. It
features a thermostat control, control lamp, and a power switch.
The thermostat knob is used to adjust the temperature inside the chamber of the heated plate
distributor. It may range from 30°C to 90°C. The control lamp (B) shows if the desired temperature has
been reached in the chamber. The power switch is used to turn on and off the device.
3.3 Operation modes and configuration of the device:
A thermostat control is used to adjust the temperature of the plate heating dispenser. It is
steplessly variable within a range of 30°C to 90°C. The control lamp for the heating elements switches
on each time the temperature in the dispenser chamber falls a few degrees.
With the plate dispensers, plates of specific diameters can be safely stored: the DPN-28 and
DPC-28 are designed for the diameters of 180-280mm, and the DPN-34 and DPC-34 for 240-340mm.
They have an adjustable six-step system of three rails protecting the plates from sliding off the platform.
In order to adjust the distributor to the plates of smaller diameter, raise a rail approximately 1 cm and
turn it to the platform (clockwise). In order to adjust the distributor to the plates of larger diameter, raise
a rail approximately 1 cm and turn it from the platform (counter-clockwise). Repeat this with each rail,
making sure the extent of adjustment is the same each time so that the plates can be located centrally
and safely.
4. MAINTENANCE

4.1 General safety rules:

All outer steel surfaces and all surfaces of the moving platform need to be cleaned daily using a
small amount of detergent and lukewarm water. After being cleaned, the surfaces should be rinsed with
cold water and dried.
Do not clean acid-resistant steel surfaces with scrapers or wire cleansers, since they can
scratch the surfaces.
If the device is not going to be used for a long time, cover its surfaces, particularly the operating
surfaces.
IMPORTANT:
Do not clean the plate heating dispenser with a water jet, since this might damage the electrical
and electronic components ensuring the proper operation of the device.

4.2 Machine cleaning and maintenance routine:

CAUTION
THE DEVICE SHOULD NEVER BE CLEANED USING A WATER JET OR SIMILAR
PRESSURE CLEANING DEVICE.
1. Turn off power switch.
2. Unplug the unit from its power source.
WAIT FOR LOW TEMPERATURE OF THE EQUIPMENT BEFORE CLEANING TO PREVENT BURNS.
CLEANING ADVICES:
5
ENGLISH