Installation And Assembly; Electric Connection - edenox DPC-28 Instrucciones De Instalación, Uso Y Mantenimiento

2.5 Installation and assembly:

The dispenser should be installed in the following order:

Remove the protective film from all metal surfaces. The dispenser must be installed in a well ventilated
room, under a ventilation hood, if possible. It can be located on a standalone base or as part of a row
consisting of other kitchen devices as well.

The dispenser should be connected to the power supply in compliance with applicable regulations.

Install and connect the device in such a way that live wires cannot be accessed without tools. The fuses
of the power system of the distributor should be designed for 10A current.

Put the dispenser in a sufficiently prepared location. The height and the levelling of the device should
adjusted before it is installed on the base.

The conductor cross-section area of the power cable for the DPC-28 and DPC-34 dispensers should
not be smaller than 1.5 mm2 (recommended cable 3x1.5 mm2).

2.6 Electric connection:


The power cable used with the device should have 3 cords, the diameters of which may not be smaller
than suggested in the manual.

Designed to be powered by 230V, 50-60Hz mains power, the device's power cable is equipped with a
PE protective conductor.

The electrical connection is at the base of the device.
WARNING:
Prior to first use, it is necessary to remove the protective substance from the surfaces of the distributor by
wiping them with a soft cloth moistened with soapy water.
3. OPERATION
3.1 General information:
Follow the instructions below to make work and operation safe, as well as to ensure the durability and
fault-free operation of the device:

Provide training for the personnel who is to use the device in the operation of professional electrical
gastronomic equipment.

The device may be repaired only by an authorised person.

Damaged components or subassemblies should be replaced with the same items or ones with similar
durability, features and technical parameters.
The following must always be observed:

Do not connect the device to the mains via a socket that is NOT provided with an earthing pin.

Do not connect the device to an electrical system that has not been checked for fire safety.

Do not clean or have the device maintained when connected to the power supply.
WARNING:
DO NOT use a water jet to clean the electrical heated plate dispenser.
The manufacturer shall not be held liable if the device is used without the observation of this manual or
outside of its intended use.
4
ENGLISH