Machine Disposal; Trouble-Shooting Information - edenox DPC-28 Instrucciones De Instalación, Uso Y Mantenimiento


To clean the stainless steel use a sponge or cloth, tepid water and neutral soap. Do not use abrasive
products, solvents, metal cleaning liquids or undiluted detergents.

Dry with a cloth afterwards.
It is advisable to clean the interior of the machine as often as possible to maintain good hygiene
standards.

The device has been designed to require very little maintenance. With normal use, cleaning is the only
form of maintenance that needs to be done on a regular basis.

4.3 Machine disposal:

The product is made up of metal parts. For any part of the appliance, please note that:

At the end of the product's life-cycle, make sure it is not dispersed in the environment.

Each part must be collected and disposed of separately, according to their different characteristics
(e.g. metals, plastic, rubber, etc.)

The public or private waste collection systems defined by local legislation must be considered.

The equipment may contain hazardous substances: the improper use or incorrect disposal may
have negative effects on human health and on the environment;

In the event of illegal disposal of electrical and electronic waste, penalties are specified by local
waste disposal legislation.
5. TROUBLE-SHOOTING

5.1Trouble-shooting information:

IMPORTANT:
Electrical subassemblies may be replaced only by an authorised service technician.
It must be made a principle to disconnect the power cable from the power supply before
electrical components are replaced.
It must be made a principle to disconnect the power cable from the power supply before
electrical components are replaced.
FAULT
The air in the
chamber of the
dispenser does not
heat up, the
switches and the
thermoregulator are
activated, the
control lamp is off.
The air in the
chamber is
insufficiently heated.
The thermostat
signalling lamp does
not switch on though
the air heats up.
POSSIBLE CAUSE
- Power supply failure.
- The terminals of the
conductors loosened on the
power strip.
- The thermoregulator or the
thermal switch is damaged.
- The switches are
damaged.
- Some heating elements
are disconnected.
- Heating elements are
damaged.
- Control lamp burnt out.
- The electrical circuit of the
control lamp is open.
6
REMEDY
Connect to power supply.
Appropriately fix the conductors to the
power strip.
Replace the damaged components.
Check that the heating elements are
properly connected.
Replace the damaged components.
Replace the control lamp.
Repair the wires of the control lamp.
ENGLISH