EdilKamin MYA Instalación Uso Y Mantenimiento página 29

g. 1
A
g.
C
E
g. 5
H
X
X
g. 7
INSTALLATION
g. 2
B
D
g. 4
G
F
G
g. 6
I
g. 8
- 29
MYA is set up to allow the ue pipe to be connected at the top
or the back.
he stove is delivered ready for the ue pipe to be tted at the
back.
o allow the ue pipe to be connected at the top, the speci c
optional e tra kit must be used (code
760680). he kit includes the following parts:
- N 1 80 clamp (L)
- N 1 inspection elbow (M)
- N 1 ue pipe outlet ( )
- N 2 top ue pipe outlet closers ( )
o t the kit, proceed as follows:
- Remove the supported glass top (A - g. 1).
- Open the door and remove the galvanised panel (B - g. 2)
- Slacken the wing nuts at the lower and upper ends on the
inside of the left side ( D - g. 4).
- lose the door and remove the plating pro les on the back
(E - g. 5).
- Remove the glass side (F - g. 6) removing the clamps ( -
g. 6).
- hen proceed to t the kit as indicated on the ne t page.
- Remove the supported glass top ( - g. 7).
- Remove the side steel, ed to the structure of the stove with
2 screws (X - Fig. 7) to remove, pulling it upwards (I - Fig. 8)
- hen proceed to t the kit as indicated on the ne t page.
-