Emergency Button; Information For Users - EdilKamin INPELLET 49 Instalación Uso Y Mantenimiento

Pellet reserve system
Before enabling the system, you need to load a sac of pellets into the tan and use the INPELLET 49 until the loaded
fuel has run out. This allows for a short system road test.
fter this, the tan can be lled completely and the INPELLET 49 started up.
hen running, at the time at which a whole 1
"Reserve" ashing.
t this point, after having poured in a sac of pellets, you need to inform the memory that you have loaded 1
To do so, proceed as follows:
1. press the " " ey (for appro imately -4 seconds) until the word " loc " appears.
. press the " " ey until the word "Reserve" appears.
. press the " " ey until the following screen appears,
g remaining in tan
then use the " " ey to ta e the gure ( ) to the value equal to the g of pellets loaded (1
4. press the " " ey to con rm
. press the ey
fter having completed the above procedure, after having consumed the 1
ashing at intervals. fter which the operation must be repeated, from point 1 to point .

EMERGENCY BUTTON

Should the remote control be bro en, the basic functions can also be accessed by means of a red emergency button
located under the e ternal hatch, on the left (see g. ).
se a screwdriver to press the button once or more to enable the function desired:
1. INPELLET 49 OFF
by pressing the red button for seconds this turns on.
. INPELLET 49 ON
by pressing the red button for seconds this turns off.
. INPELLET 49 ON
manual mode, by pressing the red button, you go from P1 to P .
4. INPELLET 49 ON
automatic mode, by pressing the red button, you go from
RADIO ANTENNA
INPELLET 49 dialogues with the remote control by means of radio waves. The radio signal is received by the radio control by
means of a small antenna beneath the e ternal hatch (see g. ). Should the signal sent from the remote control be too wea for
the control distance or other reason, the antenna can be removed from its housing by rotating it.
In accordance with rt. 1 of the Legislative Decree No. 1 1, dated
/9 /E and /1 8/E , pertaining to the reduction of hazardous substances used in electrical and electronic equipment,
as well as disposal of waste". The crossed-out wheeled bin symbol shown on the equipment or on the pac aging indicates that
the product must be disposed of separately at the end of its useful life. Therefore, at the end of the equipment s useful life, the
user must hand in the equipment to suitable collection facilities for electrical and electronic waste, or return it to the retailer
when a new, equivalent appliance is purchased in a ratio of one to one.
INSTRUCTIONS FOR USE
g sac of pellets can be loaded, the display will show the word
to e it.

INFORMATION FOR USERS

g, the wording "Reserve" will appear
to .
uly , "Implementation of Directives:
- 35
-
g.
g caricati
g in the above e ample).
emergency button
radio antenna
g.
serial port
/9 /E ,