EdilKamin FANTASY Instalación Uso Y Mantenimiento página 38

MIMIC PANEL
hold down for seconds to turn stove on or off
ressed brie y it switches the stove from manual to automatic operating mode; held down (pressed and held for
it gives access to the various programming menus.
increases the various settings
decreases the various settings
Each time it is pressed tells the electronic circuit board memory that
continuously for
ressed brie y it switches the stove s fan from the quieter " omfort level to the higher energy " urbo level.
Loading the feed screw.
Should the pellet hopper empty completely the feed screw
must be lled. o do so, eep the
taneously for a few seconds (on the remote control or synoptic
panel). nce released, REF LL will appear on the display.
his must be carried out before ignition if the stove has stopped
due to the pellets having nished.
t is quite normal for some pellet residue to remain inside the
hopper, this is what the feed screw is unable to pic up.
nce a month, fully vacuum the hopper to prevent dusty resi-
due from accumulating.
Auto atic ignition
ith the stove on standby, press the
(on the synoptic panel or remote control). his will startup
the ignition process, Start-up will appear on the display and
a countdown will commence in seconds (
preset time for the ignition process: its duration will be automa-
tically shortened if the control board detects that certain tests
have been carried out positively. he ame appears after about
minutes.
INSTRUCTIONS FOR USE
cancels any residual or previously loaded g.
" ouch in correspondence to the LE points to select the desired operating power.
lternatively, the traditional setting can be used, which can be selected using the
and eys pressed simul-
button for seconds
). here is no
g have been loaded into the tan ; pressing it
Manual ignition
t a temperature lower than
resistance to become red hot - or if the resistance is temporarily
not wor ing, you can use a relighter to ignite the stove.
nsert a well-lit relighter into the combustion chamber, close
the door and press on the synoptic panel or remote control.
Operating odes
Manual: the user sets the desired operating power (from
a minimum of to a ma imum of )
Auto atic: the user sets the desired roo
using the + - ey or the re ote control the stove reads the
setting and ad usts the power to reach the te perature set
then sets itself to Power 1.
Manual ode fro synoptic panel re ote control
ith the stove in operation mode or on standby, press and
release the E button on the synoptic panel remote
control and ower will appear on the display (showing
the power at which the stove is wor ing). ress the
the remote control to increase the operating power (from ower
to ower ). Setting the fan via the Synoptic anel
ith the stove in operation mode or on standby, rotate the
right nob to adjust the ventilation setting (from to
all powers).
- 38
-
)
- buttons.
too low for the electrical
te perature
ey on
in