Analog S 1-channel audio signals can be output from the DVD-3800
The multichannel
audio signals recorded
in packed PCM can be played when an AV amplifier
equipped
with
analog 5 l-channel
audio inputs is connected
To powe outlet
Set the "AUDIO
SETUP" default setting as shown below
(See page 18)
• "DIGITAL
OUT" _ "PCM"
"LPCM (441 kHz / 48 kHz)" _ "ON"
Playing DVDs with incorrect settings
may resulL noise that codd damage your ears or the speakers
DVD-3800
@@@@
75 _/o/ms
pM plug came (commercially
ava lable}
]
®
i
_OODDD
Digita
audi°
nput
l
CO/nector (OPTICAL
Digital audio
input
connector
(COAXIAL}
inputterminals
NOTES:
FO_
_T_t
_c_lne_
cor_r_ectlor_s
r
set
UAUD_O
CHANNEL
'_
_nde_
r'AUDIO
SETUP"
at
"SETUP
r' to
"MULTI
CHANNEL"
and make the "SPEAKER
CONFIGURATION",
"CHANNEL
LEVEL"
arid "DELAY
TIME"
settings
• Set "LPCM (441 kHz/4g kHz)" under "AUDIO SETUP" at "SETUP"
to "OFF"
(See page 18)
(If set to "ON",
analog audio signals converted
to 96 kNz/S8 2 kHz will be output
when playing sources
recorded
at 196 kHz/176 4 kHz)
• When playing DVDs that are not copyright-protected
and the unit is set to output
digital and analog audo
signals
simultaneously,
for some discs only the signals below
96 kNz for the front two channels will be
output for the analog part
When playing DVDs that are nol copyright-protected,
set "DIGITAL
OUTPUT" at "PURE DIRECT MODE"
to "OFF"
(See page 23)
• When playing DVDs recorded
in MPEG audio format,
the audio s gnals are down-mixed
to 2 channels for
output
• With the DVD-3800,
we recommend
turning the digital output
off and only outputting
analog signals
in
order to keep interference
from the digital output circuitry to the minimum
and allow you to enioy high bt,
high sampling frequency,
high quality multi-channel
sound
DVD-3800
'I[;
s/Sts
®,®,@
NOTES:
• When connecting
to a 2-channel audio stereo device, set "AUDIO
CHANNEL"
under "AUDIO
SETUP" at
"SETUP" to "2 CHANNEL"
{see page 17) For multi-channel
sources, the signals are down-mixed
into two
channels (analog)
(Only the front left and right channels are output
for sources for which down-mixing
is
prohibited)
• Set "LPCM (441 kHz/48 kHzl" under "AUDIO
SETUP" at "SETUP" to "OFF"
(See page I8)
(If set to "ON",
analog audio sgnals converted
to 48 kNz will be output
for linear PCM or packed PCM
sources)
• Set "DIGITAL
OUTPUT" at "PURE DIRECT MODE" to "OFF"
(See page 231
(If set to "ON",
analog audio signals converted
to 96 kHz/88 2 kHz will be output when
playing sources
recorded at 196 kHzJ176 4 kHz)
9