Covering Installation - EdilKamin NILO Instalación Uso Y Mantenimiento

COVERING INSTALLATION

NILO
33
screws
75
75
61
61
61
61
62
DETAIL. Z
62
bushings
24
screw
FIG. A
screws
screws
26
61
24
62
61
61
62
4
61
DETAIL. X
62
2 screws
INCLUDED HARDWARE:
2 M6x25 screws
2 M6x12 screws
4 silicone spacers for ceramic top
8 flat washers diam. 6
2 bushings
ASSEMBLING THE LATERAL TILES
Remove the rear panel (33 - by unscrewing the 3 screws
indicated in figure A) and the two profiles (75) and
insert the tiles (61) on both sides.
Reinstall the profiles (75) and the rear panel (33).
ASSEMBLING THE UPPER FRONT PANEL
Position the ceramic upper front panel (62) against the
metallic front panel support (24) located above the door.
Use an Allen key to fasten the front panel in place using
the 2 supplied M6x25 screws and the 2 supplied M6
washers (the door must be opened before performing this
operation).
NOTE:
In order to correctly install the upper front panel (62), the
supplied bushing must be positioned between it and the
metallic front panel (24), as indicated in detail "Z".
ASSEMBLING THE LOWER FRONT PANEL
Use the supplied Allen key to loosen the screws that hold
the cast iron lower front grill (4) in place and remove it.
Position the front panel (62) and use an Allen key to
fasten it in place using the 2 supplied M6x25 screws and
the 2 supplied M6 washers, as indicated in detail "X".
ASSEMBLING THE CERAMIC TOP (26).
• insert the 4 ceramics spacers into the 4 free respective
holes in the cast iron top
• position the ceramic top (26) to make sure it rests pro-
perly.
• if necessary, insert a washer between the silicone spacer
and the cast iron top.
NOTE:
• the red enamel with crystalline, applied to the
majolica, crazes (cracks) evenly over the whole surface.
Crazing is not a defect but is a characteristic of enamel
applied to majolica known as "craclè".
• The ceramic parts (majolica) are cast and enamelled
manually and may present small defects that will not
affect their quality (small dents or enamel porosity).
35