Chlorine Clear Water Plan; Ozonator Clear Water Plan - CalSpas Fitness 2400 Manual Del Usuario

Chlorine Clear Water Plan

This plan and its chemical dosages are intended for Cal
Spas chemicals only. Most chemical manufacturers use
different chemical formulas and strengths. Only Cal spas
chemicals are specially formulated to provide chemical
balance at lower dosages. Always read and follow printed
instructions on chemical bottles and packages.
Day One (Monday)
1. Test spa water using "Chlorine Test Strips".
2. Based on the Test Strip readings:
• First adjust total alkalinity (acceptable range of
80-120 ppm)
• Then adjust the pH if needed (range is between
7.2 to 7.8).
• Add 2 tablespoons of Chlorine Granules.
• The recommended level of Chlorine is 3-5
ppm.
3. Add 2 oz of "Stain and Scale Defense".
4. Remove dirty filter from the spa and rinse off.

Ozonator Clear Water Plan

This plan and its chemical dosages are intended for spas equipped with the optional
Cal Zone Quest 2000 / 3000 Ozonator (portable spas only) or Del Zone Eclipse (in-
ground models only). The chemical references are designed for Cal Spas chemicals
only.
Start Up
1. Follow the Spa Start Up procedures for Chlorine "Clear Water Plan".
2. Set the spa's filtration time for "F-4". This activates the ozonator and produces the
ozone gas. (Follow the instructions in the owner's manual)
Note: Filtration time may need to be increased with heavy bather load.
Day One (Monday)
1. Test spa water using chlorine "Test Strips". (You will need to use a small
amount of chlorine as a supplemental sanitizer.)
2. Based on the Test Strip readings:
• First adjust total alkalinity (acceptable range of 80-120 ppm),
• Then adjust the pH if needed. (Range is between 7.2 to 7.8.)
• Add 1 tablespoon of Chlorine Granules.
• The recommended level of Chlorine is 1-3 ppm.
3. Add 2 oz of "Stain and Scale Defense".
2009 Portable Spa Owner's Manual
LTR20091001, Rev. A
Water Quality Maintenance
5. Place your extra clean filter cartridge back into the
spa.
6. Vacuum debris from the bottom of your spa with the
"Spa Vacuum".
Day Two (Wednesday)
1. Test spa water using Chlorine Test Strips.
2. Based on the Test Strip reading: Adjust total alkalinity,
then the pH if needed.
Day Three (Friday)
1. Test spa water using Chlorine Test Strips.
2. Based on the Test Strip reading:
• Adjust total alkalinity, then the pH if needed.
• Add 2 tablespoons of Chlorine Granules (if
needed).
3. Add 2 oz of Oxidizer Shock to spa. Run Spa for 15
minutes with cover off.
4. Replace cover.
Page 27