Shortening The Tungsten Electrode; Connecting The Cable Assembly - Abicor Binzel ABITIG Little Serie Instructivo De Servicio

®
ABITIG Little

3.2 Shortening the tungsten electrode

3.3 Connecting the cable assembly

The electrode type is set by EN ISO 6848. The max. length of electrode
depends on the type of torch.
NOTE
• The welding performance is affected by the selection of the tungsten
electrode and by wear. A smooth, groove-free sharpened end of the
tungsten electrode has a positive effect on the welding result.
 7 Maintenance and cleaning on page EN-9
1 Plug the cable assembly connection into the power supply and secure it with
a connection nut.
2 Properly mount the connections for water supply/return, shielding gas and
control lead plug. Applies only to liquid-cooled welding torches.
WARNING
Risk of burns
Produktname will become overheated if the coolant level is too low.
• Wear protective gloves.
• Check the coolant level at regular intervals.
NOTE
• Check the minimum coolant level of the cooling unit.
• Make sure that the coolant supply and return have been installed
properly. Coolant supply = blue, Coolant return = red.
• Each time the device is commissioned or after each hose assembly
change, the cooling system must be ventilated as follows: Disconnect the
coolant return hose from the re-circulating cooling unit and hold it over a
collecting device. Close opening at the coolant return. Open it again by
repeatedly and abruptly releasing it, until the coolant is flowing
continuously and without air bubbles.
• We recommend the use of ABICOR BINZEL series BTC coolant for
liquid-cooled welding torches.
3 Putting into operation
EN - 7