Publicidad
Idiomas disponibles
Idiomas disponibles
CHANGING
LASER BATTERY
LUBRICATION
• Turn the power switch OFF and unplug the power
cord from its power source.
• LASER LIGHT - DO NOT STARE INTO BEAM,
APERTURE, or into a reflection from a mirror-like
surface.
Figure 19-1
F
Turn the power switch OFF and unplug the power cord
from its power source.
The drill press has sealed lubricated bearings in the
motor housing that do not require any additional lubrica-
tion from the operator.
The quill and spindle assemblies should be periodically
lubricated.
Lower the quill assembly and squirt or wipe
a thin film of lightweight machine oil on the entire sur-
face.
Place a few drops of light machine oil down the
spindle assembly.
Raise and lower the quill several
times to distribute the oil evenly.
D
E
C
1.
Remove battery cover (A) from laser housing.
2.
Remove the 9-volt battery from the battery compart-
ment (B).
3.
Disconnect the 9-volt battery (C) from battery
terminal (D).
4.
Connect a new 9-volt battery (not included) to
battery terminal.
5.
Place battery back into battery compartment
and
replace battery cover.
NOTE: The battery is a 9-volt standard alkaline battery
(not included).
When replacing the battery, the battery
terminals should be thoroughly cleaned.
Use a soft
paintbrush or similar device, to remove all sawdust and
debris.
CLEANING
With the drill press unplugged, blow off motor with low-
pressure air to remove dust or dirt. Air pressure above
50 P. S. I. should not be used as high-pressured air
may damage insulation.
The operator should always
wear eye protection when using compressed air.
Do not use a shop vacuum to clean metal shavings.
The metal shavings can cause an explosion or fire.
Do not allow chips and dust to accumulate under drill
press.
Keep area clean and in safe order.
CAUTION: DO NOT USE FLAMMABLE
MATERIALS
to clean the drill press.
After cleaning, apply a good quality automotive wax to
any unpainted surfaces. Make sure to buff out the wax
before assembly.
ONLY trained personnel should perform repairs to the
drill press. Contact your nearest Sears Service Center
for authorized service. Unauthorized
repairs or replace-
ment with non-factory parts could cause serious injury
to the operator and damage to the drill press.
26
Publicidad
