Brake Assembly Instructions; Controls Operation (140 L); Assembly And Disassembly Of Cutter Bar And Accessories - Bertolini 140 Uso Y Mantenimiento

6
12

BRAKE ASSEMBLY INSTRUCTIONS (140

Place the engine on a stable support.
1) Unscrew the wheel fixing screws (1).
2) Unscrew the fixing screws (2) of the axie shaft
support; fix the brake shoe half supports (4) by
using the long screws (13).
N.B.: To avoid oil leaks, it is best to unscrew the
2 screws, assemble the half-support, tighten the
2 screws and then repeat the same operation
for the other half-support.
3) Insert the brake shoes (7) on the appropriate
half-support pins.
When assembling, make sure that the brake
shoe springs are in correspondence with the axle
shaft undercuts.
4) Assemble the brake drum (8) and wheel by
means of fixing screws (1).
5) After having removed the handlebar grip, insert
lever (9) and lock it in its position by using screw
(10).
6) Screw adjuster (11) on lever (9).
7) Insert the wire on the brake lever (9) and on
the brake shoe lever control (3).
8) Adjust the lever clearance to 8 mm. by
operating on wire clamp (12) and on adjuster
(11).
9) Reassemble the grip.
38
1
2
7
- Fig. 9)
Fig. 9
8
9
Fig. 9/A
2
°
90
°
90

CONTROLS OPERATION (140 L)

Cutter Bar inclination control lever
The cutter bar is set free when using the lever (2)
and thus allowing the bar itself to travel over 90°
(Fig. 9/A). After having chosen the most suitable
working position, release the lever.
Assembly and disassembly
of Cutter Bar and accessories (Fig. 9/A)
The Mowers are equipped with a Quickfit coupling
which allows a quick and easy connection of the
implements. With engine at stand-still and machine
in horizontal position, pull the latch (1) and block it
in open position by turning 90°. Remove the
machine from the Cutter Bar or other connected
implement. Once the Cutter Bar or an implement
has been connected, turn the latch (1) until it locks
into closing position.
4
3 13
10
11
5