Operating Instructions; Auto Operation; Fan Operation - Impecca IPAC-12K Manual De Instrucciones

oPeRATInG InsTRUCTIons:

CoolInG operation
• Press the "MODE" button until the "COOL" indica-
tor light comes on .
• Press the ADJUST buttons "+" or " - " to select your
desired room temperature . The temperature can
be set within a range of 17°C-30°C/62°F-88°F .
• Press the "FAN SPEED" button to choose fan speed .
HeATInG operation
• Press the "MODE" button until the "HEAT" indica-
tor light comes on .
• Press the ADJUST buttons "+" or " - " to select your
desired room temperature . The temperature can
be set within a range of 17°C-30°C/62°F-88°F .
• Press the "FAN SPEED" button to choose the fan
speed . For some models, the fan speed can not
be adjusted under HEAT mode .
• Press the "MODE" button until the "DRY" indicator
light comes on .
• Under this mode, you cannot select a fan speed
or adjust the temperature . The fan motor oper-
ates at LOW speed .
• Keep windows and doors closed for the best
dehumidifying effect .
• Do not connect the duct to window .

AUTo operation

• When you set the air conditioner in AUTO mode,
it will automatically select cooling, heating(cool-
ing only models without), or fan only operation
depending on what temperature you have select-
ed and the room temperature .
• The air conditioner will control room temperature
automatically round the temperature point set by
you .
• Under AUTO mode, you can not select the fan speed .

FAn operation

• Press the "MODE" button until the "FAN " indicator
light comes on .
• Press the "FAN SPEED" button to choose the fan
speed . The temperature cannot be adjusted .
• Do not connect the duct to window .
TIMeR operation
• When the unit is on, press the
• Timer button will initiate the Auto-off stop pro-
gram, the TIMER OFF indicator light illuminates .
Press the UP or down button to select the de-
sired time . Press the TIMER button again within 5
seconds, the Auto-on start program is initiated .
And the TIMER ON indicator light illuminates .
Press the up or down button to select the desired
Auto-on start time .
• When the unit is off, press the Timer button to
initiate the Auto-on start program,press it again
within five seconds will initiate the Auto-off stop
program .
• Press or hold the UP or DOWN button to change
the Auto time by 0 .5 hour increments, up to 10
hours, then at 1 hour increments up to 24 hours .
Thecontrol willcountdown the time remaining
until start .
• The system will automatically revert back to dis-
play the previous temperature setting if there is
no operation in a five seconds period .
• Turning the unit ON or OFF at any time or adjust-
ing the timer setting to 0 .0 will cancel the Auto
Start/ Stop timer program .
• When the malfunction (E1,E2,E3 or E4) occurs,
the Auto Start/Stop timed program will also be
cancelled .
sleeP operation
• Press this button, the selected temperature
will increase (cooling) or decrease (heating) by
1°C/2°F after 30 minutes . The temperature will
then increase (cooling) or decrease (heating) by
another 1°C/2°F after an additional 30 minutes .
• The new temperature will be maintained for 7
hours before it returns to the originally select-
ed temperature . This ends Sleep mode and the
unit will continue to operate as originally pro-
grammed .
• NOTE: This feature is unavailabe under FAN or
DRY mode .
9