CARe & MAInTenAnCe:
IMPoRTAnT:
1) Be sure to unplug the unit before cleaning or servicing .
2) Do not use gasoline, thinner or other chemicals to clean
the unit .
3) Do not wash the unit directly under a tap or using a hose .
It may cause electrical danger .
4) If the power cord is damaged, it should be repaired by
manufacture or its agency .
AIR FIlTeR CleAnInG:
Clean the air filter at least once every two weeks to prevent
inferior fan operation because of dust .
ReMovAl: This unit has two filters . Take the upper filter out
along the the arrow direction (Figure 1), then take the filter
down . Remove the lower filter by loosening the screw, taking
out the filter as shown in (Figure 1) .
CleAnInG: Wash the air filter by immersing it gently in warm
water (about 40°C/104°F) with a neutral detergent . Rinse the
filter and dry it in a shady place .
MoUnTInG: Install the upper air filter after cleaning , and
install the lower filter by using the screw (see Figure 2) .
UnIT enClosURe:
Use a lint-free cloth soaked with neutral detergent to clean
the unit enclosure . Finish by wiping with a dry clean cloth .
beFoRe sToRInG oR noT UsInG A UnIT
FoR lonG PeRIoDs oF TIMe:
Remove the rubber plug at the back of the unit and attach a
hose to drain outlet . Place the open end of the hose directly
over the drain area in your basement floor .
(see Figures F, G, H and I on page 6)
Remove the plug from the bottom drain outlet, all the water
in the bottom tray would drain out (see Figure J on page 6)
Keep the appliance running on FAN mode for half a day in
a warm room to dry the appliance inside and prevent mold
from forming .
Stop the appliance and unplug it, wrapped the cord and bun-
dle it with the tape (Figure 3) . Clean the air filter and reinstall
it (see above) . Remove batteries from the remote controller .
12