Troubleshooting; Contact Support - Impecca IPAC-12K Manual De Instrucciones

TRoUblesHooTInG TIPs:
Problem
Unit does not start when
pressing on/off button
Room not cool enough
Machine noisy or vibrates
Gurgling noises
Power shuts off in heating mode

ConTACT sUPPoRT:

Impecca customer support can be contacted in the following methods:
• Online 24/7: www .impeccausa .com
• By e-mail:
• By phone:
P1 appears in the display window
Room temperature is lower than
the set temperature (cool mode)
The windows or doors in the room
are not closed
There are heat sources inside the
room
Exhaust air duct is not connected or
blocked
Temperature setting is too high
Air filter is blocked by dust
The ground is not level or not flat
enough
The sound comes from the flowing
of the refrigerant inside the air
conditioner unit
The automatic overheat protection
function kicks in . When the tem-
perature at the aur outlet exceeds
158°F/70°C, the device will automa-
tically shut off .
service@impeccausa .com
+1 888 .918 .3456
Possible Causes
11
Remedies
Drain the water in the bottom tray
Reset the temperature
Make sure all the windows and
doors are closed
Remove the heat sources
if possible
Connect the duct and make sure
it can function properly
Decrease the set temperature
Clean the air filter
Place the unit on a flat, level
surface if possible
This noise is normal
Switch on again after the unit has
cooled off .