Battery And Charger; Charging Instructions; Inserting Battery - Powers Fasteners TRAK-IT TOOL C3 Manual Del Operador

BATTERY AND CHARGER

BATTERY CELL AND CHARGER
The first step in preparing a new tool for operation is to fully charge the new Battery. New
Batteries are shipped discharged and must be charged for 24 hours before first use. All
subsequent charges will require a 2.5 hour minimum charge.
IMPORTANT NOTES
NOTE: BATTERY CONTAINS NICKEL METAL HYDRIDE AND MUST BE RECYCLED OR
DISPOSED OF PROPERLY.
THE TRAK-IT TOOL COMES WITH A MULTI-CELL BATTERY PACK AND ITS OWN
CHARGER. THIS BATTERY CELL AND CHARGER COMBINATION IS THE ONLY ONE
THAT WILL WORK WITH THE TRAK-IT TOOL. THE BASIC CHARGING INSTRUCTIONS
ARE AS FOLLOWS:
WARNING — CHEMICAL/EXPLOSION HAZARD READ ALL INSTRUCTIONS
BEFORE CHARGING OR USING BATTERY. FAILURE TO FOLLOW ALL INSTRUCTIONS
MAY RESULT IN FIRE, SEVERE BURNS, OR RELEASE OF TOXIC FUMES.

CHARGING INSTRUCTIONS

1. Connect the round plug of the transformer to the back of the charger base and plug the
transformer adapter into any wall outlet.
2. Place the battery firmly into the rectangular receiver of the charger base. The red LED will
appear indicating that the battery is charging.
3. The battery is fully charged when the green LED appears.
NOTE: WHEN CHARGING A NEW BATTERY FOR THE FIRST TIME, LEAVE THE BATTERY
IN THE CHARGER UNTIL THE CHARGER LED TURNS GREEN.
• Charger must be on a level surface.
• Do not charge battery when temperature is below 40 ˚F (5 ˚C).
• Do not drop battery or charger.
• Do not allow metal objects to come in contact with battery terminals.
• Do not puncture or attempt to open battery case or cells.
• Do not store battery where it will be subjected to temperatures above 120°F (49°C).
• Do not incinerate battery.
• Do not use a defective battery charger or one that overheats and/or smokes when plugged in.

INSERTING BATTERY

1. Load the Battery into the Trak-It tool handle. Battery is secure only after the two locking
latches snap into the locked position.
LOW BATTERY VOLTAGE INDICATOR LIGHT
On one side of the Handle is a small plastic lens. This is the Low Battery Voltage
Indicator Light.
The Low Battery Voltage Indictor Light will illuminate only when the battery voltage is low.
When the battery voltage is low, a red LED will illuminate indicating to the operator that it
is time to recharge the battery.
TRAK-IT TOOL MODEL C3, C3 ST
10
10