Loading Fasteners - Powers Fasteners TRAK-IT TOOL C3 Manual Del Operador

PREPARING THE TRAK-IT TOOL FOR USE
FASTENERS AND FUEL CELL
The Trak-It tool was designed specifically to be used only with Powers Fasteners fuel cells
and collated pin strips. Use of other consumables may cause tool damage and void your
warranty. Use only original Powers Fasteners consumables.

LOADING FASTENERS

The illustration below shows how to properly load fasteners into the Trak-It tool.
1. Load the fastener strips into the rear slot of the magazine.
2. Pull the carrier assembly back to the rear section of the magazine and gently release the
assembly in order to engage the fasteners.
CAUTION (PINCH POINT)
Do not allow follower to fly unrestrained when loading fasteners. Control the forward
movement upon release of the follower so that it gently engages the rearmost pin strip.
Allowing the follower to fly uncontrollably may result in a finger being pinched between
the follower and rearmost pin strip.
The Trigger on the Trak-It tool is automatically locked and will not operate when there are
no fasteners in the magazine and unless the Contact Arm is fully depressed. The purpose
of this feature is to prevent needless blank cycling (which wastes fuel) and causing
possible damage to tool components.
OUTDOOR WEATHER AND THE TRAK-IT TOOL
Use the Trak-It tool outdoors, in clear weather, when the Tool, Fuel Cell, and Battery are
between 20 ˚F (-7 ˚C) and 120 ˚F (49 ˚C). Colder temperatures may damage the Trak-It
Tool and Battery Cell. Hotter temperatures may damage the Tool and Fuel Cell.
Fuel should be stored out of direct sunlight in surroundings less than 120 ˚F (49 ˚C).
After extended periods of continuous use, cool the Tool by running the Fan Motor.
Operation when the Tool is less than 20 ˚F (-7 ˚C) may damage the tool. Fuel Cells at
cold temperatures lose the required propellant force for proper operation. Bring the Tool,
Battery Cell, and Fuel Cell above the minimum operating temperature.
TRAK-IT TOOL MODEL C3, C3 ST
UNLOADING THE FASTENERS
1. While pressing the
follower, pull back the
carrier assembly lightly,
and slide smoothly the
assembly toward the
front of the magazine.
2. Push the pin stopper and
slide the fastener strips
out of the magazine.
14
14