Air Filter - Powers Fasteners TRAK-IT TOOL C3 Manual Del Operador

SERVICING
Field service should be restricted to the following:
• CHECKING THE ENERGY LEVEL OF THE BATTERY
• RECHARGING THE BATTERY
• CHECKING THE FUEL CELL AND METERING VALVE
• REPLACING THE FUEL CELL
• CLEANING THE AIR FILTER
• CLEARING A JAM
Attempts to go beyond these procedures could result in serious personal injury or
damage to the Trak-It tool and voiding of the warranty.
There are certain problems that you may encounter when you are using the Trak-It tool
that you will be able to correct on the work site. The following field service procedures
are the only service procedures you should attempt. Anything else that may appear wrong
with the Trak-It tool should only be diagnosed and repaired by a fully trained service
technician. If you have any reason to believe that your problem is beyond the service
procedures in this manual, contact your Powers Fasteners customer service representative
immediately.
DANGER — NEVER ATTEMPT ANY MAINTENANCE OF THE TRAK-IT TOOL WITHOUT
FIRST REMOVING THE FUEL CELL AND BATTERY. MAINTENANCE SHOULD ONLY BE
STARTED AFTER THE TOOL IS COMPLETELY INOPERATIVE.
BATTERY CELL CHECK
Periodically check on the LED Battery Voltage Indicator Light---the LED in the
Handle of the Trak-It tool. When encountering a problem, the first step should always be
to make sure the Battery has enough energy to operate the tool. The battery has enough
energy when the Red LED remains unlit.
FUEL CELL CHECK
Another typical service condition will occur when the Fuel Cell becomes empty. A
typical symptom will be when the Trak-It tool's Fan operates but the tool does not drive
fasteners completely or fails to cycle at all. In this case, take the Fuel Cell out of the
tool, check to see if the Cell still contains fuel and that the Metering Valve is working.
To determine if there is any fuel left in the Fuel Cell simply place the Metering Stem
against a solid object, and gently push about three or four times. A small amount of fuel
should be released each time. Never perform this test near an open flame or sparks, while
smoking, or where the fuel may get into your eyes. If fuel is not released with each
operation of the Metering Valve, this indicates that there is no more fuel left in the
cylinder and it must be replaced. Dispose of the empty Fuel Cell properly.

AIR FILTER

Remove the Air Filter Cover by prying with a screw driver. The Air Filter will simply
lift out.
Tap the filter GENTLY or blow with compressed air to remove any dust. You should check
and clean the Air Filter every two days.
TRAK-IT TOOL MODEL C3, C3 ST
16
16