2GIG Rely Guia Instalacion página 7

Note: If your Dealer has given you an Activation Code, you will need the
IMEI value located under the back plate of the Panel. Use the mobile app to
enter this value, or Scan the QR code before connecting the battery. If desk
mounting, pass the cord through the back panel first. If mounting vertically,
nest the cord in the wire path as shown.
3. Align and insert the battery power connector end into the
receptacle in the battery compartment.
A. Plug the power connector into
the receptacle first.
B. Insert the battery, folding
the connector wire into the
recessed area next to battery,
prior to reinstalling lid and
snapping it close.
4. Reinstall cover on Panel and snap it closed.
Installing the Security Panel on a wall or flat surface
Select a location for your Panel near an available AC power source.
• Wall or vertical surface
• Desk or horizontal surface
Preparing the Panel for placement on a wall or vertical surface
1. Lift tab up and remove the cover of the Panel.
2. Position the cover (tab down - inside of plate facing you) on the
surface it will be mounted.
• Use the holes (4) in the plate as a
guide for marking where the holes
for the screws or anchors will be
drilled or inserted.
• If the installation requires inserting
the screws into drywall, four drywall
anchors are included.
3. Drill holes where marks have been
made on vertical surface.
A. Align plate with holes, ensuring it is positioned with tab down and
mounting clips on the top side.
B. Fasten plate to wall with screws and anchors, as necessary.
System Setup
7